Термоусадочное оборудование DIEBOLD - страница 36

Configuration 6.1 Switching between mm/ inch The diameter of the tool can be shown on the display in mm or in inches. Select the desired unit with up ▲ and ▼ down and confirm with OK. 6.2 Setting up of cooling time The cooling time can be extended to a maximum of 200 % of the factory setting. A cooling time less than 100 % is not possible for safety reasons. Select the desired value with up ▲ and ▼ down and confirm with OK. 6.3 Enter Start Delay (ISG3410-WK only) Around 3 seconds will pass before the generator starts. If this waiting time is too short to insert bulky tools, the Start Delay option can be used to set an additional delay of up to 30s. Select the desired value with up ▲ and ▼ down and confirm with OK. 6.4 Enter Stop Delay (ISG3410-WK only) After the selected shrinking time has ended, the coil is rapidly driven upwards. If the dwell time of the coils in the lower position is not long enough, a delay time of 30 seconds can be set in the option of the Stop Delay that enables the safe extraction of heavy tools with shrink fitting. In this case the coil stays in the lower position until the selected time has expired or unless the Stop button is activated. Select the desired value with up ▲ and ▼ down and confirm with OK. October 2015 ISG3410 36