Shrinking 5.5.3.2 Setup or change your own parameters externally (option) With the PC based program „ToolMemoryEditor“ you can define tools by yourself and read into the control with an USB memory stick. The USB interface is located at the generator module on the right side. Read in the generated file of tools: Switch off the device Plug in the USB stick Switch on the device While starting up, the new tool data is read in. The USB stick can be removed as soon as the main menu appears (see Chapter 4.3, Switching on the device, page 17). NOTE! Reading back the (changed) sets of parameters will overwrite the existing tool memory. The function „TOOL MEMORY“ is enabled with correct tool data. These are now available. 5.5.3.3 Select your own tool parameters Select with up ▲ and ▼ down the function "TOOL MEMORY" Activate with OK. A list of the generated tools appears Select with up ▲ and ▼ down the desired tool Activate with OK. The menu shrinking will be selected immediately Continue as described in Chapter 5.5.1, ThermoGrip clamping chucks: PARAMETER, page 23 October 2015 ISG3410 33